BenQ MX717 User Manual download pdf (Page 36)

Operation36

Controlling the projector through a LAN

environment

You can manage and control the projector from one or more remote computers when

they are properly connected to the same local area network.

Cable connection

If you are in a DHCP environment:

1. Take a RJ45 cable and connect one end to the RJ45 LAN input jack of the projector

and the other end to the RJ45 port on your Ethernet or router.

2. Do one of the following:

•Press NETWORK SETTING on the remote control. The Network

Settings page is displayed.

•Press MENU/EXIT and then press / until the SYSTEM SETUP:

Advanced menu is highlighted. Press to highlight Network Settings and

press ENTER. The Network Settings page is displayed.

3. Highlight Wired LAN and press ENTER.

4. Make sure the Status is Connect.

5. Press to highlight DHCP and press / to select On.

6. Press to highlight Apply and press ENTER.

7. Re-enter the Network Settings > Wired LAN page. The IP Address, Subnet

Mask, Default Gateway, and DNS settings will be displayed. Note down the IP

address displayed in the IP Address row.

If the IP Address still does not appear, contact your ITS administrator.

If you are in a non-DHCP environment:

1. Repeat steps 1-4 above.

2. Press to highlight DHCP and press / to select Off.

3. Contact your ITS administrator for information on the IP Address, Subnet Mask,

Default Gateway, and DNS settings.

4. Press to select the item you want to modify and press ENTER.

MX717

MX716

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 65 66

No comments

BenQ MX717 User Manual Page 36