BenQ W1400 User Manual download pdf (Page 39)

Using the projector

Personalizing the projector menu display

The On-Screen Display (OSD) menus can be set according to your preferences. The following settings do

not affect the projection settings, operation, or performance.

• Menu Display Time in the System Setup : Basic > Menu Settings menu sets the length of time

the OSD will remain active after your last key press. Use / to select a suitable time length.

• Menu Position in the System Setup : Basic > Menu Settings menu sets the OSD position in

five locations. Use / to select a preferred position.

• Language in the System Setup : Basic menu sets your familiar language for the On-Screen (OSD)

Menus. See "Using the menus" on page 26 for details.

• Splash Screen in the System Setup : Basic menu sets a preferred logo screen to be displayed

during projector start-up.

Locking control keys

With the control keys on the remote control and projector locked, you can prevent your projector

settings from being changed accidentally (by children, for example). When Key Lock is on, no control

keys on the remote control and projector will operate except POWER and .

To lock the keys:

1. Press MENU/EXIT and then press / until the System Setup : Advanced menu is highlighted.

2. Press to highlight Key Lock, and press / to select On. A warning message appears. Select Yes

and press MODE/ENTER. The control keys lock.

To unlock the keys, press and hold on the projector or remote control for 3 seconds.

Turning the projector off

To turn the projector off, press POWER and a warning message

appears. Press POWER again.

• The Power indicator light flashes orange and the fans run for

about two minutes to cool the lamp. The projector will not

respond to any commands until the cooling process is complete.

Once the cooling process finishes, a "Power Off Ring Tone"

will be heard.

To turn off the ring tone, see "Turning off the Power On/Off Ring Tone" on page 35 for details.

• Then, the Power indicator light is a steady orange once the cooling process has finished and fans stop.

• If the projector will not be used for an extended period, unplug the power cable from the power

outlet.

• To protect the lamp, the projector will not respond to any commands during the cooling process.

Actual lamp life may vary due to different environmental conditions and usage.

Downloaded From projector-manual.com BenQ Manuals

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 60 61

No comments

BenQ W1400 User Manual Page 39