BenQ W20000 User Manual download pdf (Page 22)

Using the projector

English

Entering the password recall procedure

1. Press and hold PRESET MODE on the projector or PRESET on the

remote control for 3 seconds. The projector will display a coded number

on the screen.

2. Write down the number and turn off your projector.

3. Seek help from the local BenQ service center to decode the number. You

may be required to provide proof of purchase documentation to verify

that you are an authorized user of the projector.

Changing the password

1. Press MENU on the projector or remote control and then press / until the Advanced Setup menu is

highlighted.

2. Press / to highlight Password and press ENTER. The Password page displays.

3. Highlight Change Password and press ENTER. The Input Current Password page displays.

4. Enter the old password.

• If the password is correct, the message 'Input New Password' displays.

• If the password is incorrect, the password error message displays lasting for three seconds, and the

message 'Input Current Password' displays for your retry. You can either press MENU to cancel the

change or try another password.

5. Enter a new password.

IMPORTANT: The digits being input will display as asterisks on-screen. Write your selected password

down here in this manual in advance or right after the password is entered so that it is available to

you should you ever forget it.

Password: __ __ __ __ __ __

Keep this manual in a safe place.

6. Confirm the new password by re-entering the new password.

7. You have successfully assigned a new password to the projector.

Remember to enter the new password next time the projector is started.

8. To leave the OSD menu, press MENU.

Disabling the password function

To disable password protection, go back to the Advanced Setup > Password >

Password menu. Highlight Password and select Off by pressing / . The

message 'Input Password' displays. Enter the current password.

• If the password is correct, the OSD menu returns to the Password

page with 'Off' shown in the row of Password. You will not have to

enter the password next time when turning on the projector.

• If the password is incorrect, the password error message displays

lasting for three seconds, and the message 'Input Password' displays

for your retry. You can either press MENU to cancel the change or try

another password.

Note that though the password function is disabled, you need to keep the old

password in hand should you ever need to re-activate the password function

by entering the old password.

Please write down the recall code, and

contact your nearest BenQ Customer

Center.

Recall code:

0 2 1 2

Recall Password

EXIT Back

Password Changed

Password

Change Password

EXIT Back

W20000-en.book Page 22 Monday, October 22, 2007 3:35 PM

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 52 53

Comments to this Manuals

No comments

BenQ W20000 User Manual Page 22

Comments to this Manuals

Related products and manuals for Data projectors BenQ W20000