Benq PE7700 User Manual download pdf (Page 19)

Using the projector and remote control

English

Using the projector and remote control

Preparations

Tur ning the power on

Follow the steps below.

1. Make sure the Power light is orange after power has been applied and the

main AC power switch is turned on.

2. Press and hold the POWER button on the projector or remote control to

turn the projector on.

The POWER button may not work while the projector is warming up.

3. The fans will be up and running. A start-up image shows on the screen for

a few seconds.

4. " Searching…." will be displayed on the screen before the projector

identifies the input signal. This message will remain on the screen until a valid signal is detected.

5. If the horizontal frequency of the input signal exceeds the range of the projector, a message reading "

Unsupported timing" will be displayed on the screen. This message will remain on-screen until you

change the input signal.

Switching input signals

The projector can be connected to multiple equipment at the same time. To

sequentially select input signals, press one of the Source buttons on the remote

control or SOURCE/ENTER on the projector.

Q When the projector is turned on, it will search for the input source you

last selected.

Q If you need to use the PIP or POP function, refer to page 22 for advanced

operation.

1. Turn all of the connected equipment on.

2. Remove the lens cap.

3. Plug the supplied power cable into the AC inlet on the

rear of the projector and turn the main AC power

switch on.

4. Plug the power cable into a wall socket and turn the

wall switch on.

PE7700-e.book Page 19 Monday, January 10, 2005 11:20 AM

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 33 34

No comments

Benq PE7700 User Manual Page 19