BenQ W703D User Manual download pdf (Page 31)

Operation 31

English

Adjusting the projected image

Adjusting the projection angle

The projector is equipped with 1 quick-release adjuster foot and 2 rear adjuster feet. These

adjusters change the image height and projection angle. To adjust the projector:

1. Press the quick-release button and lift the

ont of the projector. Once the image is

positioned where you want it, release the

quick-release button to lock the foot in

position.

2. Screw the rear adjuster foot to fine tune the

hor

izontal angle.

To retract the foot, hold up the projector while

ressing the quick-release button, then slowly

lower the projector. Screw the rear adjuster foot in

a reverse direction.

If the projector is not placed on a flat surface or the screen and the projector are not

erpendicular to each other, the projected image becomes trapezoidal. To correct this

situation, see "Correcting keystone" on page 32 for details.

• Do not look into the lens while the lamp is on. The strong light from the lamp may cause

damage to your eyes.

• Be careful when you press the adjuster button as it is close to the exhaust vent where hot

air comes from.

Auto-adjusting the image

In some cases, you may need to optimize the

picture quality. To do this, press AUTO on the

projector or remote control. Within 3 seconds,

the built-in Intelligent Auto Adjustment

function will re-adjust the values of Frequency

and Clock to provide the best picture quality.

The current source information will be

dis

played in the upper left corner of the screen

for 3 seconds.

• The screen will be blank while AUTO is functioning.

• This function is only available when PC signal (analog RGB) is selected.

2 2

BenQ W703D.book Page 31 Friday, November 25, 2011 9:49 AM

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 71 72

No comments

BenQ W703D User Manual Page 31