Benq PE7700 User Manual download pdf (Page 6)

6

Safety, regulatory and legal information

English

Safety instructions (continued)

3. Refer servicing only to qualified service

personnel.

4. To reduce the risk of electric shock, do not

disassemble this appliance. There are no

user serviceable parts inside. Take it to a

qualified technician when service or repair

is required. Incorrect reassembly can

cause a malfunction of the projector or

electric shock when the appliance is

subsequently used.

5. Do not look straight at the projector lens

during operation. The intense light beam

may damage your eyes.

6. Never replace the lamp assembly or any

electronic components unless the

projector is unplugged.

7. In some countries, the line voltage is NOT

stable. This projector is designed to

operate safely with a mains voltage

between 100 and 240 volts AC, but could

fail if power cuts or surges of ±10 volts

occur. In areas where the mains voltage

may fluctuate or cut out, it is

recommended that you connect your

projector through a power stabilizer, surge

protector or uninterruptible power supply

(UPS).

8. The lamp becomes extremely hot during

operation. Allow the projector to cool for

approximately 45 minutes prior to

removing the lamp assembly for

replacement.

9. Do not operate lamps beyond the rated

lamp life. Excessive operation of lamps

beyond the rated life could cause them to

break on rare occasions.

PE7700-e.book Page 6 Monday, January 10, 2005 11:20 AM

1 2 3 4 5 6 7 8 9 10 11 ... 33 34

Comments to this Manuals

No comments