BenQ W7500 User Manual download pdf (Page 20)

Using the projector

Preparations

1. Plug in and turn all of the connected equipment on.

2. If not already in, plug the supplied power cable into the AC inlet

on the rear of the projector.

3. Plug the power cable into a wall power outlet and turn the wall

switch on.

Please use the original accessories (e.g. power cable) only with the

device to avoid possible dangers such as electric shock and fire.

Turning the projector on

Follow the steps below.

1. Make sure the Power light is orange after power has been applied.

2. Press and hold POWER ON ( ) on the projector or remote control to turn the projector on.

3. The fans will start operating, and a start-up image displays on the screen for a few seconds while it

warms up.

The projector will not respond to further commands while it is warming up.

4. If you are prompted for a password, press the arrow keys to enter a six-digit password. See "Utilizing

the password function" on page 23 for details.

5. "Source Searching..." will be displayed on the screen before the projector identifies the input source.

This message will remain on the screen until a valid signal is detected. See "Selecting an input source"

on page 21 for details.

6. If the horizontal frequency of the input source exceeds the range of the projector, the message "No

Signal" will be displayed on the screen. This message will remain on-screen until you change the input

source to an appropriate one.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 59 60

No comments

BenQ W7500 User Manual Page 20