BenQ W7500 User Manual download pdf (Page 21)

Using the projector

Selecting an input source

The projector can be connected to multiple equipment at the same time.

When the projector is first turned on, it will attempt to reconnect with

the input source which was in use when the projector was last shut

down.

To select the video source:

• Using the remote control or projector

Press one of the Source keys on the remote control, or press SOURCE

on the projector repeatedly until your desired signal is selected.

• Using the OSD menu

1. Press MENU and then press / until the System Setup menu is

highlighted.

2. Press to highlight Input Source and press ENTER. The source selection bar displays.

3. Press / repeatedly until your desired signal is selected and press ENTER.

Once detected, the selected source information will display on the screen for seconds. If there are

multiple pieces of equipment connected to the projector, you can go back to the source selection bar

again to search for other signals.

• If you want the projector to automatically search for the signals, select On in the System Setup >

Auto Source Search menu.

• If you want to use the PIP function, see "Displaying more than one image source simultaneously" on

page 36 for details.

Fine-tuning the image size and clarity

NOTE: When

automatically

searching for a

valid input source,

the projector

cycles through

the available

signals following

the sequence

from top to

bottom as the

source selection

bar shows.

HDMI 1

HDMI 2

Video

S-Video

Component 1

Component 2

1. Adjust the projected picture to the size

that you need using the zoom ring.

2. Sharpen the picture by rotating the focus

ring.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 59 60

Comments to this Manuals

No comments

BenQ W7500 User Manual Page 21

Comments to this Manuals

Related products and manuals for Data projectors BenQ W7500