BenQ MP735 User Manual download pdf (Page 13)

Introduction 13

English

Remote control effective range

Infra-Red (IR) remote control sensor is located on the

front of the projector. The remote control must be held at

an angle within 30 degrees perpendicular to the

projector's IR remote control sensor to function correctly.

The distance between the remote control and the sensor

should not exceed 7 meters (~ 23 feet).

Make sure that there are no obstacles between the remote

control and the IR sensor on the projector that might

obstruct the infra-red beam.

Replacing the remote control battery

• Avoid excessive heat and humidity.

• There may be battery damage if the battery is incorrectly replaced.

• Replace only with the same or equivalent type recommended by the battery manufacturer.

• Dispose of the used battery according to the battery manufacturer’s instructions.

• Never throw a battery into a fire. There may be danger of an explosion.

• If the battery is dead or if you will not be using the remote control for a long time, remove

the battery to prevent damage to the remote control from possible battery leakage.

1. Remove the battery compartment cover by

sliding the cover in the direction of the

arrow.

2. Insert the supplied batteries taking note of

the polarity (+/-) as shown here.

3. Replace the cover.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 70 71

No comments

BenQ MP735 User Manual Page 13