BenQ MP780ST+ User Manual download pdf (Page 50)

Operation

Controlling the projector through a LAN

environment

Network Settings allow you to manage the projector from a computer using a web

browser when the computer and the projector are properly connected to the same local

area network.

Configuring the Wired LAN Settings

If you are in a DHCP environment:

1. Take a RJ45 cable and connect one end to the LAN input jack of the projector and

the other end to the RJ45 port.

2. Press MENU/EXIT and then press / until the SYSTEM SETUP:

Advanced menu is highlighted.

3. Press to highlight Network Settings and press MODE/ENTER. The

Network Settings page displays.

4. Press to highlight Wired LAN and press MODE/ENTER.

5. Press to highlight DHCP and press / to select On.

6. Press to highlight Apply and press MODE/ENTER.

7. Re-enter the Wired LAN page. The IP Address, Subnet Mask, Default Gateway, and

DNS settings will be displayed. Note down the IP address.

If the IP Address still does not display, contact your ITS administrator.

If you are in a non-DHCP environment:

1. Repeat steps 1-4 above.

2. Press to highlight DHCP and press / to select Off.

3. Contact your ITS administrator for information on the IP Address, Subnet Mask,

Default Gateway, and DNS settings.

4. Press to select the item you want to modify and enter the value.

5. Press to highlight Apply and press MODE/ENTER.

Configuring the Wireless LAN Settings

1. Connect the BenQ wireless dongle (optional) to the USB TYPE-A input jack of the

projector.

2. Highlight Wireless LAN in SYSTEM SETUP: Advanced > Network Settings

menu and press MODE/ENTER.

3. For AP mode connection, you need to note SSID information, then search the

projector with the same SSID in Q Presenter to start projection. For

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 103 104

No comments

BenQ MP780ST+ User Manual Page 50